In Compliance with CPSIA (Consumer Product Safety Improvement Act) 2008 Section 101 Lead Content in substrates (<300 ppm lead) and Section 108 Phthalates (<.1% DBP DEHP,DINP,DIDP)

STOCK, END-USE:

Cotton, 50/50 cotton/polyester blends, and some synthetics.

DESCRIPTION:

Metallic Jewel Ink/PF-MT Series is metallic jewel ink imparting eye-catching brilliant prints with excellent durability. It is compatible with most plastisol modifiers and additives.

Metallic Jewel Ink/PF-MT Series is formulated for light or dark color fabrics.

Note: Pre-test on actual substrate before any full production run, for adhesion, wash fastness and other desired effects.

FINISH:

Bright, Jewel finish.

SCREEN FABRIC:

Mesh counts 86T- 110T (European 34-44T) are recommended for maximum deposit without straining.

STENCIL:

Dual-sensitized direct method photo emulsion or SBQ pre-sensitized photo emulsion or equivalent.

CURE/DRYING:

Heat-cure at approximately 380-390°F (160°C) for 2 to 3 minutes. Will not air-dry.

MODIFICATIONS:

To reduce ink viscosity with RE-704, add 5% or less (by weight of ink). Reducer is to be used very sparingly and only when necessary.

SPECIAL INSTRUCTIONS:

When printing textiles, use a medium hard (65-85 durometer) squeegee.

STORAGE:

Metallic Jewel Ink responds to heat. Always store at cool room temperatures below 90°F (32°C). Avoid exposing inks to elevated temperatures before printings.

PACKAGING:

1- quart (0.945 Liter), 1-gallon (3.78 Liters), 5-gallon (18.9 Liters) containers. *30-gallon (113.4 Liters) and 55-gallon (207.9 Liters)

SAFETY & HANDLING:

Refer to Material Safety Date Sheet (MSDS) for complete information.

WASH UP SOLVENT:

T-125 – Wash up or equivalent. / SC-500 – Bio Wash up / SC-510 – Instant Bio. Wash up. (Non-Petrochemical)

MODIFIERS:

PF-GL-990 – Glitter Base / RE-704 – Clear Reducer / RE-705 – Curable Reducer

COLOR RANGE:

All colors are formulated using non leaded pigments. *Special Metallic colors available upon request. Contact us for more details!